AML M7100 User's Guide download pdf (Page 44)

Host Server List

The Connection Settings determine how the M7100 Handheld terminal will communicate

to a host server over the RF network. When the M7100 Handheld terminal first powers

up, it tries to establish a connection to an RF network. If this is successful, it will then

start a Telnet session using the settings described in this section.

During this start-up process, the M7100 will look to see if multiple host servers have

been defined in the Host Server List. If only one server is defined, the M7100 will

proceed to attempt to establish a connection with that server. However, if more than one

host server has been defined, the user will be prompted to choose a host server name

from a list of servers.

Simultaneous Hosts Connection

The M7100 will allow for two simultaneous telnet sessions. These sessions are running in

the background on separate virtual consoles (see Switching Virtual Consoles in the

previous chapter). In order to use this feature there must be two and ONLY two servers

listed in the Host Server List.

When the operator is presented the list of hosts to connect to, there will be an extra option

of connecting to both. If only one host is selected, then only one connection is made. If

the “Connect to Both” option is selected then both sessions will be active.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 130 131

No comments

AML M7100 User's Guide Page 44